Step 1: Prepare the Tools
Place the watch on a clean surface. You will need a small precision screwdriver that fits the screws on the bracelet.
Adjust the Stainless Steel Bracelet
How to Adjust the Stainless Steel Bracelet
Our stainless steel bracelets are connected by small screws between the links. You can shorten the bracelet by removing one or more links using a small screwdriver.
Important Notes
- Work on a clean, flat surface with good lighting so you do not lose the small screws.
- Keep all removed screws and links in a safe place. You may need them later if you want to lengthen the bracelet.
- Do not force the screwdriver. If a screw is tight, apply steady pressure and turn slowly to avoid stripping the head.
- After reassembly, check that every screw is tightened securely before wearing the watch.
Step 2: Locate the Screws
Identify the screws located in the center of the links you want to remove. These screws hold the links together.
Step 3: Unscrew the Links
Insert the screwdriver into the screw head and turn counterclockwise to loosen and fully remove the screw. Repeat for the screw on the other side of the link if needed.
Step 4: Remove the Excess Links
Once the screws are removed, separate and take out the unwanted links. Set the removed links and screws aside.
Step 5: Reconnect the Bracelet
Align the remaining links, insert the screws, and tighten them clockwise until they are secure. Make sure the bracelet is even on both sides.
Step 6: Check the Fit
Try the watch on and confirm the bracelet is comfortable. If it is still too long or too short, repeat the process with additional links.
Frequently Asked Questions
A: Use a small precision screwdriver that fits the screw heads on the bracelet. A common size for these screws is 1.0–1.2 mm.
A: Remove links evenly from both sides of the bracelet when possible so the clasp stays centered. Try the watch on after each adjustment.
A: Yes. Keep the removed links and screws. You can reinstall them the same way by inserting and tightening the screws.
A: Do not force it. Apply gentle, steady pressure while turning. If it will not move, contact customer support for assistance.
A: No. Removing and reinstalling bracelet links does not affect the water resistance of the watch case, as long as the crown is properly secured.
